ECK10-131A2M2M-I 256MB Memory Capacity low power System on Module (SoM) CPU module Industrial Computing Based on ST's cost-effective MPU design
[Processor model]：STM32MP131AAF3
[Processor Core]：Single Core
[Processor frequency]： 650MHz
[Memory capacity]：256MB
[Product size]：38*32*3.1mm
[Introduction]：ECK10-131A2M2M-I CPU module is carefully designed based on the STM32MP13 series processor launched by STMicroelectronics. It is a low-cost, low-power, cost-effective, and highly reliable embedded core board that uses stamp hole connections. The ECK10-13xA series core board is centered on the STM32MP13 series processor, and the power supply circuit, DDR3L memory circuit, NAND FLASH storage circuit, and Gigabit Ethernet PHY circuit are designed on the board to minimize the difficulty and cost of user baseboard design.
| Processor | STM32MP131AAF3 / STM32MP135AAF3； | |
| Single Arm Cortex-A7 core，650MHz； | ||
| Storage | Memory | On-board DDR3L SDRAM, 16-bit wide, 256MB/512MB optional; |
| FLASH | On-board 256MB/512MB parallel NAND FLASH optional; | |
| Show | 1 parallel display interface, the maximum resolution supports WXGA (1366×768@60fps) (only supported by MP135); supports 24bit, 18bit, 16bit, and 8bit parallel display output; | |
| Camera | 1 digital camera input (only supported by MP135); | |
| SDMMC | 2 channels (at most) MMC/SD/SDIO card interfaces capable of BOOT; | |
| USB | 2 USB 2.0 or 1 USB2.0 + 1 OTG interface; | |
| Audio | 4-way (up to) I2S full duplex; | |
| serial port | 4-way (maximum) UART; | |
| 3-way (maximum) USART; | ||
| SPI | 1 QSPI for BOOT; | |
| 5-way (maximum) SPI; | ||
| Ethernet | 2 (up to) Ethernet MAC, 1 10/100/1000 Ethernet PHY on board; | |
| CAN | 2 channels (up to) FDCAN (only supported by MP135); | |
| I2C | 4-way (up to) I2C; | |
| ADC | Supports up to 8 (up to) 12-bit ADC input channels; | |
| JTAG | Support System JTAG Controller; | |
| GPIO | 86 (maximum) GPIO channels, supporting interrupt function; | |
| Power Output | 1 channel 3.3V power output, maximum current 1A; | |
| 1 PMIC LDO1 software adjustable voltage (1.7-3.0V) power output, maximum current 350mA; | ||
| 1 PMIC LDO2 software adjustable voltage (1.7-3.0V) power output, maximum current 350mA; | ||
