The Ebyte ECK10-135A5M5M-I is an industrial System on Module (SoM) powered by ST's STM32MP135AAF3 single-core ARM Cortex-A7 MPU @ 650MHz, integrated with 512MB DDR3L RAM, 512MB NAND Flash, PMIC power supply circuit, and Gigabit Ethernet PHY in a compact 38x32x3.1mm stamp hole package, engineered for low-power Linux edge computing gateways and industrial control baseboards.
| Parameter | Specification | Remark |
|---|---|---|
| Model Number | ECK10-135A5M5M-I | Ebyte ECK10 Series Industrial SoM |
| Processor Model | STM32MP135AAF3 | STMicroelectronics MPU family |
| CPU Architecture & Frequency | Single-Core ARM Cortex-A7 @ 650MHz | High-efficiency, low-power industrial execution engine |
| RAM Capacity | 512MB DDR3L | Onboard high-speed memory circuit |
| Storage Capacity | 512MB NAND FLASH | Onboard non-volatile bootable storage |
| Onboard Network Circuit | Gigabit Ethernet PHY | Reduces carrier board layout complexity |
| Package & Form Factor | PCB Stamp Hole (Castellated Holes) | SMT surface-mount soldering design |
| Physical Dimensions | 38 * 32 * 3.1 mm | Ultra-compact footprint for embedded space |
| Operating System Support | Embedded Linux System | ST OpenSTLinux / Yocto BSP ecosystem |
| Processor | STM32MP131AAF3 / STM32MP135AAF3； | |
| Single Arm Cortex-A7 core，650MHz； | ||
| Storage | Memory | On-board DDR3L SDRAM, 16-bit wide, 256MB/512MB optional; |
| FLASH | On-board 256MB/512MB parallel NAND FLASH optional; | |
| Show | 1 parallel display interface, the maximum resolution supports WXGA (1366×768@60fps) (only supported by MP135); supports 24bit, 18bit, 16bit, and 8bit parallel display output; | |
| Camera | 1 digital camera input (only supported by MP135); | |
| SDMMC | 2 channels (at most) MMC/SD/SDIO card interfaces capable of BOOT; | |
| USB | 2 USB 2.0 or 1 USB2.0 + 1 OTG interface; | |
| Audio | 4-way (up to) I2S full duplex; | |
| serial port | 4-way (maximum) UART; | |
| 3-way (maximum) USART; | ||
| SPI | 1 QSPI for BOOT; | |
| 5-way (maximum) SPI; | ||
| Ethernet | 2 (up to) Ethernet MAC, 1 10/100/1000 Ethernet PHY on board; | |
| CAN | 2 channels (up to) FDCAN (only supported by MP135); | |
| I2C | 4-way (up to) I2C; | |
| ADC | Supports up to 8 (up to) 12-bit ADC input channels; | |
| JTAG | Support System JTAG Controller; | |
| GPIO | 86 (maximum) GPIO channels, supporting interrupt function; | |
| Power Output | 1 channel 3.3V power output, maximum current 1A; | |
| 1 PMIC LDO1 software adjustable voltage (1.7-3.0V) power output, maximum current 350mA; | ||
| 1 PMIC LDO2 software adjustable voltage (1.7-3.0V) power output, maximum current 350mA; | ||
